Search Results Found 1000 Cases.
Alarm Contents
TH ERROR
A TH error was detected during reading from an input device. The read code that caused the TH error and how many statements it is from the block can be verified in the diagnostics screen.
Alarm Contents
TV ERROR
An error was detected during the single–block TV error. The TV check can be suppressed by setting bit 0 (TVC) of parameter No. 0000 to “0”.
Alarm Contents
TOO MANY DIGIT
Data entered with more digits than permitted in the NC instruction word. The number of permissible digits varies according to the function and the word.
Alarm Contents
INVALID BREAK POINT OF WORDS
NC word(s) address + numerical value not in word format. This alarm is also generated when a custom macro does not contain a reserved word, or does not conform to the syntax.
Alarm Contents
NO DATA AFTER ADDRESS
NC word(s) address + numerical value not in word format. This alarm is also generated when a custom macro does not contain a reserved word, or does not conform to the syntax.
Alarm Contents
ILLEGAL USE OF MINUS SIGN
A minus sign (–) was specified at an NC instruction word or system variable where no minus signal may be specified.
Alarm Contents
ILLEGAL USE OF DECIMAL POINT
A decimal point (.) was specified at an address where no decimal point may be specified, or two decimal points were specified.
Alarm Contents
IMPROPER NC-ADDRESS
An illegal address was specified, or parameter 1020 is not set.
Alarm Contents
IMPROPER G-CODE
An unusable G code is specified.
Alarm Contents
FEED ZERO ( COMMAND )
1) The cutting feedrate instructed by an F code has been set to 0. 2) This alarm is also generated if the F code instructed for the S code is set extremely small in a rigid tapping instruction as the tool cannot cut at the programmed lead.